Printer Firmware can be found here: https://github.com/makerbase-mks/Klipper-for-MKS-Boards/tree/main/MKS%20Robin%20Nano%20V3.x
- Follow the instructions for Fluidd (https://docs.fluidd.xyz/installation/fluiddpi) or MainsailOS (https://docs.mainsail.xyz/setup/mainsail-os) on how to install it on a raspberry pi.
- Flash the above mentioned firmware to the printer by putting it on the root of the SD-Card
- SSH into your Fluidd or Mainsail instance and execute
ls /dev/serial/by-id/*when the printer is online after the flash. - Copy the configuration file(s) to your Fluidd och MainsailOS instance and update the serial line under
[mcu]with the output of the previous point. - You should now be able to connect and see the printer in Fluidd or Mainsail.
- The printer configuration supplied here should serve as a starting point, there are more that can and should be configured, please read below and configure what is applicable.
You can follow the guide here: https://3dprintbeginner.com/klipper-on-flsun-super-racer/ for more detailed steps and instructions, change as applicable for the Nano 3 Board.
The below steps should be reviewed and configured as applicable.
- Probe Calibration - https://www.klipper3d.org/Probe_Calibrate.html
- Delta Calibration - https://www.klipper3d.org/Delta_Calibrate.html
- Bed Mesh - https://www.klipper3d.org/Bed_Mesh.html
- Pressure Advance - https://www.klipper3d.org/Pressure_Advance.html
- Slicers - https://www.klipper3d.org/Slicers.html
- Endstop Phase (Optional) - https://www.klipper3d.org/Endstop_Phase.html
- Resonance Compensation (Optional) - https://www.klipper3d.org/Resonance_Compensation.html