macro-start.cfg

[gcode_macro START_PRINT]
gcode:
    {% set BED_TEMP = params.BED_TEMP|default(60)|float %}
    {% set EXTRUDER_TEMP = params.EXTRUDER_TEMP|default(200)|float %}

    {% set OFFSET = params.OFFSET|default(0)|float %}
    {% set PRESSURE_ADVANCE = params.PRESSURE_A|default(0)|float %}
    
    M104 S{ EXTRUDER_TEMP }     # Heat up Nozzle
    M140 S{ BED_TEMP }          # Heat up Bed

    G90                             # Absolute
    SET_GCODE_OFFSET Z={ OFFSET }   # Reset the G-Code Z offset (adjust Z offset if needed)
    SET_PRESSURE_ADVANCE ADVANCE={ PRESSURE_ADVANCE }
    G28                         # Home the printer
    
    M190 S{BED_TEMP}            # Wait for bed to reach temperature
    M109 S{EXTRUDER_TEMP}       # Wait for nozzle to reach temperature
    
    G92 E0                      # Reset extrusion distance
    G1 E3.0 F200                # Extrude filament
    G92 E0                      # Reset extrusion distance

    G1 Z150 F3000               # Move the nozzle

    G1 Z0.15 F300               # Move the nozzle very close to the bed