Skip to content

LKx Pro touchscreen firmware. Should work with Alfawise U30 Pro and Longer LK5 Pro

Notifications You must be signed in to change notification settings

Guizz27/DWIN_LK4Pro

Repository files navigation

NOTICE

This repository will soon be archived. I do not plan on using this project anymore for the screen firmware. I have another project I started that will replace this.

DWIN_LKxPro

Screen firmware for Longer LK4/LK5 Pro. should also work with Alfawise U30 Pro although the boot screen has the Longer3D logo.

IMPORTANT!! Do not try to update a LK5 Pro if your current screen version (in About screen) has letters "TL5", "DWJT" or "DWJTB".

Only use this screen firmware with this version of Marlin https://github.com/Guizz27/Marlin---Longer-LKx-Pro

Installation

Below you will find brief installation instructions for the screen firmware. Baddflash write a more detailed instructions that also covers the installation of the printer firmware. Take a look here: https://github.com/Baddflash/LK4-Pro-Firmware-Tutorial

To update the screen firmware you need to use a SD card 32GB or less formatted with FAT32 and 4096 bytes allocation units

How to install

  1. Use a pre-built version from the release page https://github.com/Guizz27/DWIN_LK4Pro/releases.
  2. In the Assets section, download the DWIN_SET.zip
  3. Unzip it into a folder called DWIN_SET and copy it in the root of a SD card.
  4. Make sure the printer is turned off
  5. Insert the SD card in the screen SD card slot. You need to disassemble the screen mounting frame to access the card slot
  6. Turn on the printer
  7. Wait for the update to complete. It will say "end" when it's done
  8. Turn off the printer and remove the SD card.
  9. Turn the printer on, you should have the new screen.

Very important, the printer firmware also has to be updated.

How to build

Follow these steps if you prefer to use the source files instead of the already prepared DWIN_SET.zip from the release page.

  1. Execute BuildRelease.bat.
  2. This creates a folder called "Release" with a subfolder "DWIN_SET".
  3. Copy this DWIN_SET folder on the SD card then
  4. Make sure the printer is turned off
  5. Insert the SD card in the screen SD card slot. You need to disassemble the screen mounting frame to access the card slot
  6. Turn on the printer
  7. Wait for the update to complete. It will say "end" when it's done
  8. Turn off the printer and remove the SD card.
  9. Turn the printer on, you should have the new screen.

Disclaimer

You use this firmware at your own risk and I am not responsible for damages it may cause.

About

LKx Pro touchscreen firmware. Should work with Alfawise U30 Pro and Longer LK5 Pro

Topics

Resources

Stars

Watchers

Forks

Packages

No packages published