The PiicoDev® LiPo Expansion Board for Raspberry Pi Pico is a great way to start experimenting with Raspberry Pi Pico/RP2040. Thanks to the onboard PiicoDev connector, you can quickly and easily connect to the PiicoDev family of sensor modules without soldering.
- Breaks out each Pico pin, with handy labels
- Take your project on the go with on-board LiPo battery charging.
- PiicoDev connector, compatible with Qwiic and STEMMA QT (3.3V only)
- Manufactured and supported in Australia by Core Electronics
Technical Details
- Dimensions: 51x51mm
- M2.5 mounting holes
- Charge current: approx 220mA / 440mA (when Fast Charge jumper is soldered)
- PiicoDev connector: I2C0 (SCL:Pin 9, SDA:Pin 8)
- PiicoDev connector pinout:
- 1 GND
- 2 3.3V
- 3 SDA
- 4 SCL
- The I2C Bus presented at the PiicoDev connector contains series 120Ohm resistances to prevent destructive signal undershoot. Refer to the schematic for more information. To operate without these series resistors, users may connect directly to the GPIO instead.
This project is open source - please review the LICENSE.md file for further licensing information.
If you have any technical questions, or concerns about licensing, please contact technical support on the Core Electronics forums.
"PiicoDev" is a registered trademark of Core Electronics Pty Ltd