Find other ways to install YunoHost here.
-
A Raspberry Pi model 1 or 2
-
An SD card: 4GB capacity (or more) and class10 speed rate are highly recommended
-
An other computer to read this guide and access to your Raspberry Pi
-
A screen and a keyboard are recommended to control your Raspberry Pi if a problem occurs.
-
A reasonable ISP, preferably with a good and unlimited upstream bandwidth
-
The YunoHost Raspberry Pi image, available here (to unzip):
http://build.yunohost.org/yunohost4rpi2.img.7z
Warning: The default network device is set to `eth0` by default. You may have to change it if your network does not work properly. In order to do that :- Connect locally to your Raspberry Pi
- Retrieve your network device's name: `$ ip link` (*lo* is the loopback device, so it should be `eth1`)
- Edit the configuration file `/etc/network/interfaces` and replace *eth0* by your network device's name
- Restart networking service: `$ sudo service networking restart`
- Connect via SSH: [email protected] (password: yunohost)
- Change root password:
passwd root - Upgrade system:
apt-get update && apt-get dist-upgrade && rpi-update
If you need help during one of these steps, do not hesitate to use our support tools.