Skip to content

Latest commit

 

History

History
29 lines (19 loc) · 1.16 KB

README.md

File metadata and controls

29 lines (19 loc) · 1.16 KB

DIY-Stevenson-Screen

Image

Notes

You'll also need 4 stainless steel threaded rods you can source anywhere to push through the 4 channels that line up when you put them together. That gives it lateral strength and you can mount it either top or bottomside

You will also need a bottom plate below the last segment to protect the inner tube channel (where the sensors should be placed) from ground IR/UV reflection that could taint measurement results

It's up to you to place a fan above the channel (in areas where some forced convection is needed to get air flowing through it) - in most cases the design was made with natural convection in mind, so that warmer air in the outside channel would rise up and therefore also triggering air movement within the channel that is fed from the bottom.

Corrections, Updates, Enhancements and PRs are always welcome.

Watch Videos of actual prints

Timelapse Record of DIY-Stevenson-Screen Print

License

CERN OHL 1.2